ELECTRONICS

FCI Electronics

Manual Part No. 144000-001

Issued: Date (10/24/94)

Page 7 of 10

Rev. 03/08/01 ECR V103118

Revision B

K\DCU\Manuals

IV. PARTS REPLACEMENT

PROCEDURES

A. Anvil Replacement

Replace anvils when they show excessive wear or become

cracked or chipped.

Removal

1

Remove the cap screw securing the anvil holder assembly

to the hand tool (see Figure 6) and then remove the anvil

holder assembly.

Figure 6

2

Loosen the two setscrews in the anvil holder and remove

the terminal holder (see Figure 7).

Figure 7

3

Remove the cap screw and defective anvil(s) from the

anvil holder (see Figure 8).

Figure 8

Installation

NOTE

When replacing the anvils, be sure that the part number for

the new anvil(s) is the same as the one being replaced.

1

Loosely install the new anvils to the anvil holder

with the attaching cap screw (See Figure 8).

2

Reinstall the anvil holder onto the hand tool and

tighten the attaching cap screw.

3

Cut out two strips of paper. Then fold the strips in

half and place them over the anvils (see Figure 9).

Figure 9

4

Slowly close the hand tool lever completely. This will

align the anvils to the crimpers. Then tighten the anvil

cap screw and release the lever. Next, remove the

paper from the anvils.

5

Reinstall the terminal holder to the anvil holder. Make

sure that the flats on the end of the terminal holder

guide pins face the setscrews in the anvil holder. Then

tighten the anvil holder set screws.

6

Crimp a terminal to the proper size wire. Then inspect

the terminal as described in section II, paragraph B.

CAUTION

To prevent the anvils from being

damaged during alignment, place a

piece of paper over the anvils.

PDM: Rev:B

Released

STATUS:

Printed: Dec 20, 2002