CS4299 datasheet(31/52 Pages) CIRRUS

31 / 52 page

CS4299

4.20

S/PDIF Control Register (Index 68h)

SPEN

S/PDIF Enable. The SPEN bit enables S/PDIF data transmission on the S/PDIF_OUT pin.

The SPEN bit routes the left and right channel data from the AC ’97 controller, the digital mix-

er, or the digital effects engine to the S/PDIF transmitter block. The actual data routed to the

S/PDIF block is controlled through the AMAP/SM[1:0] configuration in the AC Mode Control

Val

Validity. The V bit is mapped to the V bit (bit 28) of every sub-frame. If this bit is ‘0’, the signal

is suitable for conversion or processing.

Sample Rate. The Fs bit indicates the sampling rate for the S/PDIF data. The inverse of this

bit is mapped to bit 25 of the channel status block. When the Fs bit is ‘clear’, the sampling

frequency is 48 kHz. When ‘set’, the sampling frequency is 44.1 kHz. The actual rate at which

S/PDIF data are being transmitted solely depends on the master clock frequency of the

CS4299. The Fs bit is merely an indicator to the S/PDIF receiver.

Generation Status. The L bit is mapped to bit 15 of the channel status block. For category

codes 001xxxx, 0111xxx and 100xxxx, a value of ‘0’ indicates original material and a value of

‘1’ indicates a copy of original material. For all other category codes the definition of the L bit

is reversed.

CC[6:0]

Category Code. The CC[6:0] bits are mapped to bits 8-14 of the channel status block.

Emph

Data Emphasis. The Emph bit is mapped to bit 3 of the channel status block. If the Emph bit

is ‘1’, 50/15us filter pre-emphasis is indicated. If the bit is ‘0’, no pre-emphasis is indicated.

Copy

/Audio

Audio / Non-Audio. The /Audio bit is mapped to bit 1 of the channel status block. If the /Audio

bit is ‘0’, the data transmitted over S/PDIF is assumed to be digital audio. If the /Audio bit is

‘1’, non-audio data is assumed.

Pro

Professional/Consumer. The Pro bit is mapped to bit 0 of the channel status block. If the Pro

bit is ‘0’, consumer use of the audio control block is indicated. If the bit is ‘1’, professional use

is indicated.

Default

0000h

For a further discussion of the proper use of the channel status bits see application note AN22: Overview of Digital

Audio Interface Data Structures [3].

D15

D14

D13

D12

D11

D10

SPEN

Val

CC6

CC5

CC4

CC3

CC2

CC1

CC0

Emph

Copy /Audio

Pro

CS4299 датащи(PDF) 31 Page - Cirrus Logic

CS4299 датащи(HTML) 31 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

датащи скачать

ссылки URL