RL78 Family

EEPROM Emulation Library Pack02 Ver.1.01

Release Note

R20UT2645EJ0100

Rev.1.00

Page 10 of 15

Mar 28, 2014

(4) Specifying the link directive file

In the CubeSuite+ Project Tree window, right-click the File node, click Add, and then click Add File. The Add

Existing File dialog box is displayed (as shown in Figure 6-8).

Click the Files of type drop-down list, select Link Directive File (*.dr;*.dir), and then register the link directive

file that has the same name as the user-created program.

Figure 6-8. Specifying the Link Directive File

(5) Building

On the CubeSuite Build menu, click Build Project to build the project.

6.3

Notes at Build

(1) When the on-chip debugging function is in use

After the on-chip debugging function is enabled in the CubeSuite+, building a program generates the following

type of error.

This error occurs when the segment for the monitor area (OCDROM) used by the on-chip debugging function

cannot be allocated. Therefore, to avoid this error, add the following code to the link directive file (*.dr)

embedded in the project and prepare a separate area for allocating the segment.

Note: 1. xxxxx: Start address at where the error has occurred

2. The area name "OCD_ROM" is a reference example.

1

3

2

4

RA78K0R error E3212: Default segment can't allocate to memory - ignored

Segment '??OCDROM' at xxxxxH-200H

MEMORY OCD_ROM : ( 0xxxxxH, 00200H )