MP8352 – 3V to 6V INPUT, 6A, 600KHz STEP-DOWN WITH SYNCHRONOUS GATE DRIVER

MP8352 Rev. 1.0

www.MonolithicPower.com

9

1/25/2010

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2010 MPS. All Rights Reserved.

APPLICATION INFORMATION

Setting the Output Voltage

The external resistor divider is used to set the

output voltage (see the schematic on front

page). The feedback resistor R1 also sets the

feedback loop bandwidth with the internal

compensation capacitor (see Figure 1). Choose

R1 to be around 40.2kΩ for optimal transient

response. R2 is then given by:

1

V

8

.

0

V

1

R

2

R

=

Table 1—Resistor Selection for Common

Output Voltages

R1 (kΩ)

R2 (kΩ)

1.8

40.2 (1%)

32.4 (1%)

2.5

40.2 (1%)

19.1 (1%)

3.3

40.2 (1%)

13 (1%)

Selecting the Inductor

A 1µH to 10µH inductor with a DC current rating

of at least 25% percent higher than the

maximum load current is recommended for

most applications. For highest efficiency, the

inductor DC resistance should be less than

15mΩ. For most designs, the inductance value

can be derived from the following equation.

OSC

L

IN

OUT

IN

OUT

f

I

V

)

V

V

(

V

L

×

∆

×

−

×

=

Choose inductor current to be approximately

30% if the maximum load current, 6A. The

maximum inductor peak current is:

2

I

I

I

L

LOAD

)

MAX

(

L

∆

+

=

Under light load conditions below 100mA, larger

inductance is recommended for improved

efficiency.

Synchronous MOSFET

The external synchronous MOSFET is used to

supply current to the inductor when the internal

high-side switch is off. It reduces the power loss

significantly when compared against a Schottky

rectifier.

Table 2 lists example synchronous MOSFETs

and manufacturers.

Table 2—Synchronous MOSFET Selection

Guide

Part No.

Manufacture

AM4874

Analog Power

Si7848

Vishay

Selecting the Input Capacitor

The input current to the step-down converter is

discontinuous, therefore a capacitor is required to

supply the AC current to the step-down converter

while maintaining the DC input voltage. Use low

ESR capacitors for the best performance. Ceramic

capacitors with X5R or X7R dielectrics are

highly recommended because of their low ESR

and small temperature coefficients. For most

applications, a 22µF capacitor is sufficient.

Since the input capacitor (C1) absorbs the input

switching current it requires an adequate ripple

current rating. The RMS current in the input

capacitor can be estimated by:

⎟

⎟

⎠

⎞

⎜

⎜

⎝

⎛

×

−

×

=

IN

OUT

IN

OUT

LOAD

1

C

V

V

1

V

V

I

I

where:

2

I

I

LOAD

1

For simplification, choose the input capacitor

whose RMS current rating greater than half of

the maximum load current.