LNBH26 datasheet(18/38 Pages) STMICROELECTRONICS

18 / 38 page

I²C bus interface

LNBH26

18/38

Doc ID 022771 Rev 1

I²C bus interface

Data transmission from the main microprocessor to the LNBH26 and vice versa takes place

through the 2-wire I²C bus interface, consisting of the 2-line SDA and SCL (pull-up resistors

to positive supply voltage must be externally connected).

6.1

Data validity

As shown in

Figure 8, the data on the SDA line must be stable during the high semi-period

of the clock. The HIGH and LOW state of the data line can only change when the clock

signal on the SCL line is LOW.

6.2

Start and stop condition

As shown in

Figure 9, a start condition is a HIGH to LOW transition of the SDA line while

SCL is HIGH. The stop condition is a LOW to HIGH transition of the SDA line while SCL is

HIGH. A STOP condition must be sent before each START condition.

6.3

Byte format

Every byte transferred to the SDA line must contain 8 bits. Each byte must be followed by an

acknowledge bit. The MSB is transferred first.

6.4

Acknowledge

The master (microprocessor) puts a resistive HIGH level on the SDA line during the

acknowledge clock pulse (see

Figure 10). The peripheral (LNBH26) which acknowledges

must pull down (LOW) the SDA line during the acknowledge clock pulse, so that the SDA

line is stable LOW during this clock pulse. The peripheral which has been addressed must

generate acknowledge after the reception of each byte, otherwise the SDA line remains at

the HIGH level during the ninth clock pulse time. In this case the master transmitter can

generate the STOP information in order to abort the transfer. The LNBH26 does not

generate acknowledge if the VCC supply is below the undervoltage lockout threshold (4.7 V

typ.).

6.5

Transmission without acknowledge

If detection of the acknowledge of the LNBH26 is not required, the microprocessor can use

a simpler transmission: it simply waits one clock without checking the slave acknowledging,

and sends the new data. This approach is of course less protected from misworking and

decreases noise immunity.

LNBH26 датащи(PDF) 18 Page - STMicroelectronics

LNBH26 датащи(HTML) 18 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL