AD13280SLASHPCB datasheet(16/28 Pages) AD

16 / 28 page

AD13280

Rev. C | Page 16 of 28

POWER SUPPLIES

Care should be taken when selecting a power source. Linear

supplies are strongly recommended. Switching supplies tend

to have radiated components that may be received by the

AD13280. Each of the power supply pins should be decoupled

as close as possible to the package using 0.1 μF chip capacitors.

The AD13280 has separate digital and analog power supply

pins. The analog supplies are denoted AVCC, and the digital

supply pins are denoted DVCC. AVCC and DVCC should be

separate power supplies because the fast digital output swings

can couple switching current back into the analog supplies.

Note that AVCC must be held within 5% of 5 V. The AD13280 is

specified for DVCC = 3.3 V because this is a common supply for

digital ASICs.

OUTPUT LOADING

Care must be taken when designing the data receivers for the

AD13280. The digital outputs drive an internal series resistor

(for example, 100 Ω) followed by a gate like 75LCX574. To

minimize capacitive loading, there should be only one gate on

each output pin. An example of this is shown in the evaluation

board schematic (see Figure 20). The digital outputs of the

AD13280 have a constant output slew rate of 1 V/ns.

A typical CMOS gate combined with a PCB trace has a load of

approximately 10 pF. Therefore, as each bit switches, 10 mA

(10 pF × 1 V ÷ 1 ns) of dynamic current per bit flows in or out

of the device. A full-scale transition can cause up to 120 mA

(12 bits × 10 mA/bit) of transient current through the output

stages. These switching currents are confined between ground

and the DVCC pin. Standard TTL gates should be avoided

because they can appreciably add to the dynamic switching

currents of the AD13280. It should also be noted that extra

capacitive loading increases output timing and invalidates

timing specifications. Digital output timing is guaranteed with

10 pF loads.

AD13280/PCB датащи(PDF) 16 Page - Analog Devices