EP2C8 datasheet(21/36 Pages) ALTERA

номер детали	EP2C8

подробное описание детали	Enhanced Configuration (EPC) Devices Datasheet

PDF	36 Pages

Scroll/Zoom	100%

производитель	ALTERA [Altera Corporation]

домашняя страница	http://www.altera.com

Logo

21 / 36 page

Functional Description

Page 21

Enhanced Configuration (EPC) Devices Datasheet

January 2012

Altera Corporation

Programming using External Flash Interface

This method allows parallel programming of the flash memory using the 16-bit data

bus. An external processor or FPGA acts as the flash controller and has access to

programming data using a communication link such as UART, Ethernet, and PCI. In

addition to the program, erase, and verify operations, the external flash interface

supports block or sector protection instructions.

External flash interface programming is only allowed when the configuration

controller has relinquished flash access by tri-stating its internal interface. If the

controller has not relinquished flash access during configuration or JTAG-based ISP,

you must hold the controller in reset before initiating external programming. The

controller can be reset by holding the FPGA nCONFIG line at a logic low level. This

keeps the controller in reset by holding the nSTATUS-OE line low, allowing external

flash access.

1 If initial programming of the EPC device is done in-system using the external flash

interface, the controller must be kept in reset by driving the FPGA nCONFIG line low to

prevent contention on the flash interface.

EP2C8 датащи(PDF) 21 Page - Altera Corporation