L6482H datasheet(31/73 Pages) STMICROELECTRONICS

31 / 73 page

L6482

Functional description

Doc ID 023768 Rev 2

31/73

switch input events do not cause interrupts and the switch status information is at the user’s

disposal (Table 36, Section 9.1.20).

The switch input can be used by GoUntil and ReleaseSW commands as described in

Section 9.2.10 and Section 9.2.11.

If the SW input is not used, it should be connected to VDD.

6.15

Programmable gate drivers

The L6482 integrates eight programmable gate drivers that allow the fitting of a wide range

of applications.

The following parameters can be adjusted:

●

gate sink/source current (IGATE)

●

controlled current time (tCC)

●

turn-off overboost time (tOB).

During turn-on, the gate driver charges the gate forcing an IGATE current for all the controlled

current time period. At the end of the controlled current phase the gate of the external

MOSFET should be completely charged, otherwise the gate driving circuitry continues to

charge it using a holding current.

This current is equal to IGATE for the low-side gate drivers and 1 mA for the high-side ones.

During turn-off, the gate driver discharges the gate sinking an IGATE current for all the

controlled current time period. At the beginning of turn-off an overboost phase can be

added: in this case the gate driver sinks an IOB current for the programmed tOB period in

order to rapidly reach the plateau region. At the end of the controlled current time the gate of

the external MOSFET should be completely charged, otherwise the gate driving circuitry

discharges it using the integrated Miller clamp.

Figure 14.

External switch connection

AM15044v1

External

Switch

L6482H датащи(PDF) 31 Page - STMicroelectronics