THS4532IPWR datasheet(24/44 Pages) TI

24 / 44 page

THS4532

SLOS829 – FEBRUARY 2013

www.ti.com

Due to the voltage divider on the output formed by the load component values, the amplifier’s output is

attenuated. The column “Atten” in Table 3 shows the attenuation expected from the resistor divider. When using

a transformer at the output as shown in Figure 70, the signal will see slightly more loss due to transformer and

line loss, and these numbers will be approximate. The standard output load used for most tests is 2k

Ω with

associated 37.9dB of loss.

Frequency Response, and Output Impedance

The circuit shown in Figure 70 is used to measure the frequency response of the amplifier.

A network analyzer is used as the signal source and the measurement device. The output impedance of the

network analyzer is 50

Ω and is DC coupled. RIT and RG are chosen to impedance match to 50Ω and maintain

the proper gain. To balance the amplifier, a 49.9

Ω resistor to ground is inserted across RIT on the alternate input.

The output is routed to the input of the network analyzer via 50

Ω coax. For 2k load, 37.9dB is added to the

measurement to refer back to the amplifier’s output per Table 3.

For output impedance, the signal is injected at VOUT with VIN left open. The voltage drop across the 2x RO

resistors is measured with a high impedance differential probe and used to calculate the impedance seen looking

into the amplifier’s output.

Distortion

At 1MHz and above, the circuit shown in Figure 70 is used to measure harmonic, intermodulation distortion, and

output impedance of the amplifier.

A signal generator is used as the signal source and the output is measured with a spectrum analyzer. The output

impedance of the signal generator is 50

Ω and is AC coupled. RIT and RG are chosen to impedance match to 50Ω

and maintain the proper gain. To balance the amplifier, a 0.22µF cap and 49.9

Ω resistor to ground is inserted

across RIT on the alternate input. A low-pass filter is inserted in series with the input to reduce harmonics

generated at the signal source. The level of the fundamental is measured and then a high-pass filter is inserted

at the output to reduce the fundamental so it does not generate distortion in the input of the spectrum analyzer.

Distortion in the audio band is measured using an audio analyzer. Refer to audio measurement section for detail.

Slew Rate, Transient Response, Settling Time, Overdrive, Output Voltage, and Turn-On/Off Time

The circuit shown in Figure 71 is used to measure slew rate, transient response, settling time, overdrive

recovery, and output voltage swing. Turn on and turn off times are measured with 50

Ω input termination on the

PD input, by replacing the 0.22µF capacitor with 49.9

Ω resistor.

Submit Documentation Feedback

Product Folder Links :THS4532

THS4532IPWR датащи(PDF) 24 Page - Texas Instruments

THS4532IPWR датащи(HTML) 24 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

датащи скачать

ссылки URL