ADM1024 datasheet(18/28 Pages) AD

18 / 28 page

ADM1024

–18–

REV. 0

INTERRUPT

STATUS

INTERRUPT

STATUS

MASKING

DATA

FROM BUS

INTERRUPT MASK

REGISTERS 1 AND 2

(SAME BIT ORDER AS

STATUS REGISTERS)

2.5V/EXT.

TEMP 2

VCCP1

VCC

+5V

INT. TEMP

EXT. TEMP1

FAN1/AIN1

FAN2/AIN2

INT ENABLE

INT CLEAR

INT

16 MASK BITS

+12V

VCCP2

RESERVED

THERM

D1 FAULT

D2 FAULT

HIGH

LIMIT

VALUE

LOW

LIMIT

1 = OUT

LIMIT

HIGH

AND

LOW

LIMIT

COMPARA-

TORS

DATA

DEMULTI-

PLEXER

FROM

VALUE

AND LIMIT

REGISTERS

CHANNEL

MODE

VID0–VID4

REGISTERS

VID0/IRQ0

VID1/IRQ1

VID2/IRQ2

VID3/IRQ3

VID4/IRQ4

CONFIGURATION

STATUS

BIT

MASK

BIT

MASK GATING

CONFIGURATION

THERM

CLEAR

THERM

Figure 21. Interrupt Register Structure

to be asserted. After masking, the status bits are all OR’d

together to produce the

INT output, which will pull low if any

unmasked status bit goes high, i.e., when any measured value

goes out of limit. The ADM1024 also has a dedicated output for

temperature interrupts only, the

THERM input/output Pin 2.

The function of this is described later.

The

INT output is enabled when Bit 1 of Conﬁguration Register 1

(

INT_Enable) is high, and Bit 3 (INT_Clear) is low.

The

INT pin has an internal, 100 k

Ω pull-up resistor.

VID/IRQ INPUTS

The processor voltage ID inputs VID0 to VID4 can be reconﬁg-

ured as interrupt inputs by setting Bit 7 of the Channel Mode

interrupt inputs, with VID0/IRQ0 to VID2/IRQ2 being active

low and VID2/IRQ2 and VID4/IRQ4 being active high. The

individual interrupt inputs can be enabled or masked by setting

or clearing Bits 4 to 6 of the Channel Mode Register and Bits

6 and 7 of Conﬁguration Register 2 (address 4Ah). These interrupt

inputs are not latched in the ADM1024, so they do not require

clearing as do bits in the Status Registers. However, the external

interrupt source should be cleared once the interrupt has been

serviced, or the interrupt request will be reasserted.

INTERRUPT CLEARING

Reading an Interrupt Status Register will output the contents of

the Register, then clear it. It will remain cleared until the moni-

toring cycle updates it, so the next read operation should not be

performed on the register until this has happened, or the result

will be invalid. The time taken for a complete monitoring cycle

is mainly dependent on the time taken to measure the fan speeds,

as described earlier.

The

INT output is cleared with the INT_Clear bit, which is Bit

3 of the Conﬁguration Register, without affecting the contents

of the Interrupt (

INT) Status Registers.

ADM1024 датащи(PDF) 18 Page - Analog Devices

ADM1024 датащи(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL