Analog Integrated Circuit Device Data

10

Freescale Semiconductor

33982

ELECTRICAL CHARACTERISTICS

STATIC ELECTRICAL CHARACTERISTICS

POWER OUTPUT (CONTINUED)

Output Negative Clamp Voltage

-20

–

-15

V

Over-temperature Shutdown(13)

160

175

190

Over-temperature Shutdown Hysteresis(13)

5.0

–

20

CONTROL INTERFACE

Input Logic High-voltage(14)

–

–

V

Input Logic Low-voltage(14)

–

–

0.2 x

V

Input Logic Voltage Hysteresis(15)

100

600

1200

mV

Input Logic Pull-down Current (SCLK, IN, SI)

5.0

–

20

μA

RST Input Voltage Range

4.5

5.0

5.5

V

SO, FS Tri-state Capacitance(16)

–

–

20

pF

Input Logic Pull-down Resistor (RST) and WAKE

100

200

400

k

Ω

Input Capacitance(16)

–

4.0

12

pF

WAKE Input Clamp Voltage(17)

7.0

–

14

V

WAKE Input Forward Voltage

-2.0

–

-0.3

V

SO High-state Output Voltage

–

–

V

FS, SO Low-state Output Voltage

–

0.2

0.4

V

SO Tri-state Leakage Current

-5.0

0.0

5.0

μA

Input Logic Pull-up Current (18)

5.0

–

20

μA

FSI Input Pin External Pull-down Resistance

FSI Disabled, HS Indeterminate

FSI Enabled, HS OFF

FSI Enabled, HS ON

–

6.0

30

0.0

10

–

1.0

14

–

k

Ω

Notes

13.

Guaranteed by process monitoring. Not production tested.

14.

Upper and lower logic threshold voltage range applies to SI, CS, SCLK, RST, IN, and WAKE input signals. The WAKE and RST signals

15.

No hysteresis on FSI and wake pins. Parameter is guaranteed by process monitoring but is not production tested.

16.

Input capacitance of SI, CS, SCLK, RST, and WAKE. This parameter is guaranteed by process monitoring but is not production tested.

17.

The current must be limited by a series resistance when using voltages > 7.0 V.

18.

Table 4. Static Electrical Characteristics (continued)

Characteristics noted under conditions 4.5 V

≤ V

Characteristic

Symbol

Min

Typ

Max

Unit