082-8003-404 datasheet(4/24 Pages) MAGNETROL

4 / 24 page

50-613 Kotron Series 82 CE RF Level Transmitter

1.0

Complete Installation

This section provides detailed procedures for properly

installing, configuring, and, as needed, troubleshooting the

Kotron Series 82 CE RF Level Transmitter.

1.1

Unpacking

Unpack the instrument carefully. Make sure all components

have been removed from the packing material. Check

all the contents against the packing slip and report any

discrepancies to the factory.

Before proceeding with the installation, do the following:

• Inspect all components for damage. Report any damage

to the carrier within 24 hours.

• Make sure the nameplate model number agrees with the

packing slip and purchase order.

• Record the model and serial numbers for future reference

when ordering parts.

1.2

Electrostatic Discharge (ESD)

Handling Procedure

Magnetrol’s electronic instruments are manufactured to the

highest quality standards. These instruments use electronic

components that may be damaged by static electricity pre-

sent in most work environments.

The following steps are recommended to reduce the risk of

component failure due to electrostatic discharge.

• Ship and store circuit boards in anti-static bags. If an anti-

static bag is not available, wrap the board in aluminum

foil. Do not place boards on foam packing materials.

• Use a grounding wrist strap when installing and removing

circuit boards. A grounded workstation is recommended.

• Handle circuit boards only by the edges. Do not touch

components or connector pins.

• Make sure that all electrical connections are completely

made and none are partial or floating. Ground all

equipment to a good, earth ground.

082-8003-404 датащи(PDF) 4 Page - Magnetrol International, Inc.