SPEC No.

LCY-12T09303B

MODEL No.

LS013B4DN02

PAGE

23

8. Module outline

8-1) Outline dimention of the 1.3” （96×96） panel with FPC type

fig.8-1

fig. 8-2

＜

Recommended Connector＞

SMK (Bottom Contact) FP12 Series: CFP-4610-0150F

8-2) FPC Bend Specification

When bending FPC, bend where specified in Condition (1) and the bend R should be more than R specified in Condition

(2). FPC is not to contact glass edge, and there should be no stress to connective area between panel and FPC.

Condition (1) FPC bend recommended area: 0.8mm – 6.0mm from glass edge.

Condition (2) Minimum bend R: Inner diameter R0.45

Fig.8-3

【

Remark 8-1】 Do not bend backward (toward UV protection film side)

【

Remark 8-2】 Bend frequency: 3 times or less (Repeat bend condition: 180°∼ 0°)

＜

Recommended Connector of 180 degree bent FPC＞

SMK （Contact side: upper side ） FP-12 series ： CFP-4510-0150F