ATmega325P datasheet(148/364 Pages) ATMEL

148 / 364 page

148

8023F–AVR–07/09

ATmega325P/3250P

• Description of wake up from Power-save or ADC Noise Reduction mode when the timer is

clocked asynchronously: When the interrupt condition is met, the wake up process is started

on the following cycle of the timer clock, that is, the timer is always advanced by at least one

before the processor can read the counter value. After wake-up, the MCU is halted for four

cycles, it executes the interrupt routine, and resumes execution from the instruction following

SLEEP.

• Reading of the TCNT2 Register shortly after wake-up from Power-save may give an incorrect

result. Since TCNT2 is clocked on the asynchronous TOSC clock, reading TCNT2 must be

done through a register synchronized to the internal I/O clock domain. Synchronization takes

place for every rising TOSC1 edge. When waking up from Power-save mode, and the I/O clock

(clk

I/O) again becomes active, TCNT2 will read as the previous value (before entering sleep)

until the next rising TOSC1 edge. The phase of the TOSC clock after waking up from Power-

save mode is essentially unpredictable, as it depends on the wake-up time. The recommended

procedure for reading TCNT2 is thus as follows:

Write any value to either of the registers OCR2A or TCCR2A.

Wait for the corresponding Update Busy Flag to be cleared.

Read TCNT2.

• During asynchronous operation, the synchronization of the Interrupt Flags for the

asynchronous timer takes 3 processor cycles plus one timer cycle. The timer is therefore

advanced by at least one before the processor can read the timer value causing the setting of

the Interrupt Flag. The Output Compare pin is changed on the timer clock and is not

synchronized to the processor clock.

16.9.1

Timer/Counter Prescaler

Figure 16-12. Prescaler for Timer/Counter2

The clock source for Timer/Counter2 is named clk

T2S. clkT2S is by default connected to the main

system I/O clock clk

IO. By setting the AS2 bit in ASSR, Timer/Counter2 is asynchronously

clocked from the TOSC1 pin. This enables use of Timer/Counter2 as a Real Time Counter

(RTC). When AS2 is set, pins TOSC1 and TOSC2 are disconnected from Port C. A crystal can

10-BIT T/C PRESCALER

TIMER/COUNTER2 CLOCK SOURCE

clk

I/O

clk

T2S

TOSC1

AS2

CS20

CS21

CS22

PSR2

Clear

clk

ATmega325P датащи(PDF) 148 Page - ATMEL Corporation

ATmega325P датащи(HTML) 148 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL