ATmega162 datasheet(169/324 Pages) ATMEL

169 / 324 page

169

2513K–AVR–07/09

ATmega162/V

txclk

Transmitter clock. (Internal Signal)

rxclk

Receiver base clock. (Internal Signal)

xcki

Input from XCK pin (internal Signal). Used for synchronous slave operation.

xcko

Clock output to XCK pin (Internal Signal). Used for synchronous master

operation.

fosc

XTAL pin frequency (System Clock).

Internal Clock

Generation – The

Baud Rate Generator

Internal clock generation is used for the asynchronous and the synchronous master modes of

operation. The description in this section refers to Figure 76.

The USART Baud Rate Register (UBRR) and the down-counter connected to it function as a

programmable prescaler or baud rate generator. The down-counter, running at system clock

(fosc), is loaded with the UBRR value each time the counter has counted down to zero or when

the UBRRL Register is written. A clock is generated each time the counter reaches zero. This

clock is the baud rate generator clock output (= fosc/(UBRR+1)). The Transmitter divides the

baud rate generator clock output by 2, 8 or 16 depending on mode. The baud rate generator out-

put is used directly by the receiver’s clock and data recovery units. However, the recovery units

use a state machine that uses 2, 8 or 16 states depending on mode set by the state of the

UMSEL, U2X and DDR_XCK bits.

Table 70 contains equations for calculating the baud rate (in bits per second) and for calculating

the UBRR value for each mode of operation using an internally generated clock source.

Note:

1. The baud rate is defined to be the transfer rate in bit per second (bps).

BAUD Baud rate (in bits per second, bps)

OSC

System Oscillator clock frequency

UBRR Contents of the UBRRH and UBRRL Registers, (0 - 4095)

Some examples of UBRR values for some system clock frequencies are found in Table 78 (see

page 191).

Table 70. Equations for Calculating Baud Rate Register Setting

Operating Mode

Equation for Calculating

Baud Rate(1)

Equation for Calculating

UBRR Value

Asynchronous Normal Mode

(U2X = 0)

Asynchronous Double Speed

Mode (U2X = 1)

Synchronous Master Mode

BAUD

fOSC

UBRR 1

()

---------------------------------------

UBRR

fOSC

BAUD

------------------------ 1

–

BAUD

fOSC

UBRR 1

()

-----------------------------------

UBRR

fOSC

BAUD

-------------------- 1

–

BAUD

fOSC

UBRR 1

()

-----------------------------------

UBRR

fOSC

BAUD

-------------------- 1

–

ATmega162 датащи(PDF) 169 Page - ATMEL Corporation

ATmega162 датащи(HTML) 169 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL