| поискавой системы для электроныых деталей |
|
ATmega162 датащи(PDF) 168 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATmega162 датащи(HTML) 168 Page - ATMEL Corporation |
|
168 / 324 page ![]() 168 2513K–AVR–07/09 ATmega162/V AVR USART vs. AVR UART – Compatibility The USART is fully compatible with the AVR UART regarding: • Bit locations inside all USART Registers • Baud Rate Generation • Transmitter Operation • Transmit Buffer Functionality • Receiver Operation However, the receive buffering has two improvements that will affect the compatibility in some special cases: • A second Buffer Register has been added. The two buffer registers operate as a circular FIFO buffer. Therefore the UDR must only be read once for each incoming data! More important is the fact that the Error Flags (FE and DOR) and the ninth data bit (RXB8) are buffered with the data in the receive buffer. Therefore the status bits must always be read before the UDR Register is read. Otherwise the error status will be lost since the buffer state is lost. • The Receiver Shift Register can now act as a third buffer level. This is done by allowing the received data to remain in the serial Shift Register (see Figure 75) if the Buffer Registers are full, until a new start bit is detected. The USART is therefore more resistant to Data OverRun (DOR) error conditions. The following control bits have changed name, but have same functionality and register location: • CHR9 is changed to UCSZ2. • OR is changed to DOR. Clock Generation The Clock Generation logic generates the base clock for the Transmitter and Receiver. The USART supports four modes of clock operation: Normal asynchronous, Double Speed asyn- chronous, Master synchronous and Slave synchronous mode. The UMSEL bit in USART Control and Status Register C (UCSRC) selects between asynchronous and synchronous oper- ation. Double Speed (asynchronous mode only) is controlled by the U2X found in the UCSRA Register. When using synchronous mode (UMSEL = 1), the Data Direction Register for the XCK pin (DDR_XCK) controls whether the clock source is internal (Master mode) or external (Slave mode). The XCK pin is only active when using synchronous mode. Figure 76 shows a block diagram of the clock generation logic. Figure 76. Clock Generation Logic, Block Diagram Signal description: Prescaling Down-Counter / 2 UBRR / 4 / 2 fosc UBRR+1 Sync Register OSC XCK Pin txclk U2X UMSEL DDR_XCK 0 1 0 1 xcki xcko DDR_XCK rxclk 0 1 1 0 Edge Detector UCPOL |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |