TLE8262E datasheet(13/93 Pages) INFINEON

13 / 93 page

Data Sheet

Rev. 1.0, 2009-03-31

TLE8262E

State Machine

4.2.7

SBC Software Flash Mode

SBC Software Flash Mode is similar to SBC Normal Mode regarding voltage regulators. In this mode, the Limp

Home output can be set to active LOW via SPI and the communication on CAN and LIN modules is activated to

receive flash data. In the LIN module the slope control mechanism is switched off. The Watchdog configuration is

fixed to the settings used before entering the SBC SW Flash Mode. When the device comes from SBC Normal

Mode, a reset is generated at the transition.

From the SBC Software Flash Mode, the SBC goes into SBC Restart Mode, the config setting has no influence

on the behavior. A mode change to SBC Restart Mode can be caused by a SPI command, a time-out or Window

Watchdog failure or an undervoltage reset. When leaving the SBC Software Flash Mode a reset is generated.

4.2.8

SBC Restart Mode

They are multiple reasons to enter the SBC Restart Mode and multiple SBC behaviors described in Table 2.

In any case, the purpose of the SBC Restart Mode is to reset the microcontroller.

•

From SBC SW Flash Mode, it is used to start the new downloaded code.

•

From SBC Normal, SBC Stop Mode and SBC SW Flash Mode it is reached in case of undervoltage on

cc1µC,

or due to incorrect Watchdog triggering.

•

From SBC Sleep Mode it is used to ramp up

cc1µC after wake

•

From SBC Init Mode, it is used to avoid the system to remain undefined.

•

From SBC Fail-safe Mode it is used to ramp up

cc1µC after wake or cool down of Vcc1µC.

From SBC Restart Mode, the SBC goes automatically to SBC Normal Mode. The delay time tRDx is programmable

by the “Reset delay” SPI bit. The Reset output (RO) is released at the transition. SBC Restart Mode is left

automatically by the SBC without any microcontroller influence. The first SPI output data will provide information

about the reason for entering Restart Mode. The reason for entering Restart Mode is stored and kept until the

microcontroller reads the corresponding “LH0..2” or “RM0..1” SPI bits. In case of a wake up from Sleep Mode the

wake source is seen at the interrupt bits (Configuration select 000), an interrupt is not generated.

Entering or leaving the SBC Restart Mode will not result in deactivation of the Limp Home output (if activated).

The first SPI output data when going to SBC Normal Mode will always indicate the reason for the SBC Restart

event.

TLE8262E датащи(PDF) 13 Page - Infineon Technologies AG