PSD913F2 datasheet(50/94 Pages) STMICROELECTRONICS

50 / 94 page

PSD9XX Family

Preliminary Information

The

PSD9XX

Functional

Blocks

(cont.)

9.4.2.4 Address In Mode

For microcontrollers that have more than 16 address lines, the higher addresses can be

connected to Port A, B, C, and D. The address input can be latched by the address strobe

(ALE/AS). Any input that is included in the DPLD equations for the Main Flash, Secondary

Flash, or SRAM is considered to be an address input.

9.4.2.5 Data Port Mode

Port A can be used as a data bus port for a microcontroller with a non-multiplexed

address/data bus. The Data Port is connected to the data bus of the microcontroller. The

general I/O functions are disabled in Port A if the port is configured as a Data Port.

9.4.2.6 JTAG ISP

Port C is JTAG compliant, and can be used for In-System Programming (ISP). For more

information on the JTAG Port, refer to section 9.6.

9.4.2.3 Address Out Mode

For microcontrollers with a multiplexed address/data bus, Address Out Mode can be used

to drive latched addresses onto the port pins. These port pins can, in turn, drive external

devices. Either the output enable or the corresponding bits of both the Direction Register

and Control Register must be set to a ‘1’ for pins to use Address Out Mode. This must be

done by the MCU at run-time. See Table 22 for the address output pin assignments on

Ports A and B for various MCUs.

For non-multiplexed 8 bit bus mode, address lines A[7:0] are available to Port B in

Address Out Mode.

Note: Do not drive address lines with Address Out Mode to an external memory device if

it is intended for the MCU to boot from the external device. The MCU must first boot from

PSD memory so the Direction and Control register bits can be set.

Microcontroller

Port A (3:0)

Port A (7:4)

Port B (3:0)

Port B (7:4)

8051XA (8-Bit)

N/A*

Address (7:4)

Address (11:8)

N/A

80C251

N/A

Address (11:8)

Address (15:12)

(Page Mode)

All Other

Address (3:0)

Address (7:4)

Address (3:0)

Address (7:4)

8-Bit Multiplexed

8-Bit

N/A

Address [3:0]

Address [7:4]

Non-Multiplexed Bus

Table 22. I/O Port Latched Address Output Assignments

N/A = Not Applicable.

PSD913F2 датащи(PDF) 50 Page - STMicroelectronics

PSD913F2 датащи(HTML) 50 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94

датащи скачать

ссылки URL