DLS360 datasheet(10/40 Pages) CLARKE

10 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

GENERAL TECHNOLOGY

• PSI: Pounds per square inch - Common unit measure used for water pressure,

air pressure, hydraulic pressure and pounds of force.

• LPM: Litres per minute - common unit measure used for flow rate of water.

• Bypass Mode: In bypass mode, the high pressure pump recirculates water

because the spray gun trigger has not been pressed.

DIESEL ENGINE

1. Air Filter: The air filter prevents airborne contaminants from entering the engine.

2. Fuel Tank: The fuel tank is a reservoir that holds the diesel fuel.

3. Start Motor: It is powered by the battery and engages the flywheel in motion to

start the engine.

4. Fuel Switch: To turn ‘ON’ or ‘OFF’ the fuel supply to the injection pump.

5. Recoil Starter: Use for starting the engine manually.

6. Decompression Lever: This helps to start the engine by reducing the effort needed

to pull the recoil starter handle.

HIGH PRESSURE WATER PUMP

1. Pump Model & Serial Number: It contains the year, month and day of production,

and can track the batch of materials, assembler and tester. Please provide the

serial no. along with the pump model and version when ordering spare parts and

reporting any issues of concern.

2. Pressure Adjusting Knob: Used to raise or reduce the pressure by turning the

knob.

3. Detergent Injector: Use to siphon detergent or other pressure washer chemicals

into the low pressure stream.

4. Water Outlet Connector: To connect the high pressure hose.

5. Water Inlet with Filter Screen: Used to connect a garden hose to the washer.

ALWAYS have the filter screen present when in use.

6. Red Shipping Plug Attached with Vent Plug: The pump is shipped with a RED

SHIPPING PLUGS to prevent oil leaking during transportation. ALWAYS replace

with the attached vent plugs before using.

7. Thermal Relief Valve: Cycles water through the pump when the water reaches

125-155oF / 50-68oC. Warm water will discharge from the pump onto the ground.

This valve can prevent internal pump damage (see page 14).

8. High Pressure Turning Valve: This is a valve that can discharge the air in the

pump and water in-take pipeline, enhance pump sucking ability, and allow to suck

from a barrel of 1m deep.

DLS360 датащи(PDF) 10 Page - Clarke International