2

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE Shot Blast Cabinet which is designed for

professional workshop use.

Before attempting to operate the cabinet, please read this manual

thoroughly and carefully follow all instructions given. In doing so you will ensure

the safety of yourself and that of others around you, and you can also look

forward to the product giving you long and satisfactory service.

Carefully unpack the unit, and check against the list on page 3 to ensure that

no damage was caused in transit. Should any damage be apparent, please

contact your Clarke dealer immediately.

FEATURES

The 3 cu/ ft cabinet is lit by a low voltage (12 volt, 4 watt) 500 Lumens LED light,

fed from a plug-in type transformer. The switch-box is mounted on the left side

of the cabinet. The transformer should be plugged directly into the mains

supply and connected to the switchbox which contains an ON/OFF rocker

switch.

Air is extracted via a double filtration system at the right hand side of the

cabinet.

Please note that when vacuum extraction is used, air will be drawn into the

cabinet through the hole on the back panel of the unit. The hole is covered on

the outside with a filter plate and housed within the plate is a foam filter, which

must always be in place. This is to prevent grit from being blown out, when

vacuum extraction is NOT used.

The lid is provided with a double clear plastic window, the inner of which may

be renewed quickly and easily if it should become damaged by the media

blasting action.

A variety of abrasive nozzles is supplied with the unit to produce a useful range

of power and grit densities to satisfy all requirements. The cabinet is designed

for use with dry abrasives ONLY. We recommend Aluminium Oxide (for

cleaning steel) and Glass Beads (for cleaning aluminium).

It is necessary to provide a clean, dry air supply, capable of delivering a

minimum of 10 cuft/min at a maximum 100psi. Please consult your air

compressor manual, ensuring you comply with all safety precautions for the

use of air compressors and observe all necessary precautions when using

compressed air.