ST7FOXK2 datasheet(201/226 Pages) STMICROELECTRONICS

201 / 226 page

ST7FOXF1, ST7FOXK1, ST7FOXK2

Electrical characteristics

201/226

12.8

EMC (electromagnetic compatibility) characteristics

Susceptibility tests are performed on a sample basis during product characterization.

12.8.1

Functional EMS (electromagnetic susceptibility)

Based on a simple running application on the product (toggling two LEDs through I/O ports),

the product is stressed by two electromagnetic events until a failure occurs (indicated by the

LEDs).

●

ESD: Electrostatic Discharge (positive and negative) is applied on all pins of the device

until a functional disturbance occurs. This test conforms with the IEC 1000-4-2

standard.

●

FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD and

VSS through a 100 pF capacitor, until a functional disturbance occurs. This test

conforms with the IEC 1000-4-4 standard.

A device reset allows normal operations to be resumed. The test results are given in the

table below based on the EMS levels and classes defined in application note AN1709.

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and

prequalification tests in relation with the EMC level requested for his application.

●

Software recommendations

The software flowchart must include the management of runaway conditions such as:

–

Corrupted Program Counter

–

Unexpected reset

–

Critical Data corruption (control registers...)

●

Prequalification trials

Most of the common failures (unexpected reset and Program Counter corruption) can

be reproduced by manually forcing a low state on the RESET pin or the Oscillator pins

for 1 second.

To complete these trials, ESD stress can be applied directly on the device, over the

range of specification values. When unexpected behavior is detected, the software can

be hardened to prevent unrecoverable errors occurring (see application note AN1015).

Table 83.

EMS test results

Symbol

Parameter

Conditions

Level/

Class

VFESD

Voltage limits to be applied on any I/O pin

to induce a functional disturbance

VDD=5V, TA=+25 °C, fOSC=8MHz

conforms to IEC 1000-4-2

VFFTB

Fast transient voltage burst limits to be

applied through 100pF on VDD and VSS

pins to induce a functional disturbance

VDD=5V, TA=+25 °C, fOSC=8MHz

conforms to IEC 1000-4-4

ST7FOXK2 датащи(PDF) 201 Page - STMicroelectronics

ST7FOXK2 датащи(HTML) 201 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL