PM6670 datasheet(38/53 Pages) STMICROELECTRONICS

38 / 53 page

Application information

PM6670

38/53

Application information

The purpose of this chapter is to show the design procedure of the switching section.

The design starts from three main specifications:

●

The input voltage range, provided by the battery or the AC adapter. The two extreme

values (VINMAX and VINmin ) are important for the design.

●

The maximum load current, indicated by ILOAD,MAX.

●

The maximum allowed output voltage ripple VRIPPLE,MAX.

It's also possible that specific designs should involve other specifications.

The following paragraphs will guide the user into a step-by-step design.

8.1

External components selection

The PM6670 uses a pseudo-fixed frequency, Constant On-Time (COT) controller as the

core of the switching section. The switching frequency can be set by connecting an external

divider to the VOSC pin. The voltage seen at this pin must be greater than 0.8V and lower

than 2V in order to ensure system's linearity.

Nearly constant switching frequency is achieved by the system's loop in steady-state

operating conditions by varying the On-Time duration, avoiding thus the need for a clock

generator. The On-Time one shot duration is directly proportional to the output voltage,

sensed at VSNS pin, and inversely proportional to the input voltage, sensed at the VOSC

pin, as follows:

Equation 24

where KOSC is a constant value (130ns typ.) and τ is the internal propagation delay

(40ns typ.).

The duty cycle of the buck converter is, under steady state conditions, given by

Equation 25

The switching frequency is thus calculated as

Equation 26

OSC

SNS

OSC

OUT

OSC

OUT

OSC

SNS

OSC

OUT

⋅

PM6670 датащи(PDF) 38 Page - STMicroelectronics

PM6670 датащи(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

датащи скачать

ссылки URL