USB2524 datasheet(40/57 Pages) SMSC

40 / 57 page

USB MultiSwitchTM Hub

Datasheet

Revision 1.91 (08-22-07)

SMSC USB2524

DATASHEET

7.2

EEPROM Interface

The SMSC Hub can be configured via a 2-wire (I2C) EEPROM (256x8). (please see Table 4.2, "SMBus

or EEPROM Interface Behavior" for specific details on how to enable configuration via an I2C

EEPROM).

The Internal state-machine will, (when configured for EEPROM support) read the external EEPROM

for configuration data. The hub will then “attach” to the upstream USB port.

Note: The Hub does not have the capability to write, or “Program”, an external EEPROM. The Hub

only has the capability to read external EEPROMs. The external eeprom will be read (even if

it is blank or non-populated), and the hub will be “configured” with the values that are read.

Please see Internal Register Set (Common to EEPROM and SMBus) for a list of data fields available.

7.2.1

I2C Master

The I2C EEPROM interface implements a subset of the I2C Master Specification (Please refer to the

Philips Semiconductor Standard I2C-Bus Specification for details on I2C bus protocols). The Hub’s I2C

EEPROM interface is designed to attach to a single “dedicated” I2C EEPROM, and it conforms to the

Standard-mode I2C Specification (100kbit/s transfer rate and 7-bit addressing) for protocol and

electrical compatibility.

Note: Extensions to the I2C Specification are not supported.

The Hub acts as the master and generates the serial clock SCL, controls the bus access (determines

which device acts as the transmitter and which device acts as the receiver), and generates the START

and STOP conditions.

7.2.1.1

Implementation Characteristics

The Hub will only access an EEPROM using the Sequential Read Protocol.

7.2.1.2

Pull-Up Resistor

The Circuit board designer is required to place external pull-up resistors (10K

Ω recommended) on the

SDA/SMBDATA & SCL/SMBCLK/CFG_SELO lines (per SMBus 1.0 Specification, and EEPROM

manufacturer guidelines) to Vcc in order to assure proper operation.

7.2.1.3

I2C EEPROM Slave Address

Slave address is 1010000.

Note: 10-bit addressing is NOT supported.

7.2.2

In-Circuit EEPROM Programming

The EEPROM can be programmed via ATE by pulling RESET_N low (which tri-states the Hub’s

EEPROM interface and allows an external source to program the EEPROM).

USB2524 датащи(PDF) 40 Page - SMSC Corporation

USB2524 датащи(HTML) 40 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

датащи скачать

ссылки URL