FS2101 datasheet(14/48 Pages) HP

14 / 48 page

POD 9

Header 9

16554/5/6/7

expander 2

card POD 1

16550 expander

card Pod 3

POD 10

Header 10

16554/5/6/7

expander

card POD 2

16550 expander

card Pod 4

POD 11

Header 11

16554/5/6/7

expander

card POD 3

16550 expander

card Pod 5

PCI Active Analysis Probe Header 4 contains 8 User Defined

pins. These pins are available to the user to connect whatever

additional signals the users wishes to view along with the PCI

bus. These pins are located below POD 3 on the PCI Active

Analysis Probe module and clearly marked

. These user pins are

available on the logic analyzer on POD 11 channels 15 thru 8.

These pins may be used to connect the individual IDSEL signals

from other PCI slots or the bus grant signals from the PCI bus

arbitration logic.

The PCI Active Analysis Probe can be installed in any slot of the

PCI Local bus. The following steps explain how to install the PCI

Active Analysis Probe into the PCI Local bus.

Install the logic analyzer cables as described in the

previous section.

Power off the PCI target. Align the PCI module with the

appropriate slot on the target system and plug the

module into the PCI connector. Power on the logic

analyzer and then power on the target.

If your PCI Local bus is 32 bits the upper portion of the edge

connector will not be inserted into any connector. This will not

affect the modules operation on a 32-bit PCI Local bus.

USER PINS

Installing the PCI

Active Analysis

Probe

FS2101 датащи(PDF) 14 Page - Agilent(Hewlett-Packard)

FS2101 датащи(HTML) 14 Page - Agilent(Hewlett-Packard)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

датащи скачать

ссылки URL