NXP Semiconductors

PCA9537

4-bit I2C-bus and SMBus low power I/O port with interrupt and reset

16 Revision history

Document ID

Release date

Data sheet status

Change notice

Supersedes

PCA9537 v.7

20210908

Product data sheet

202104008A

PCA9537 v.6

Modifications

• Updated ordering information to reflect discontinuation of ATP-1 device and move to ASEN. See

change notice column.

• The terms "master" and "slave" changed to "controller" and "target" to comply with NXP inclusive

language policy.

PCA9537 v.6

20171107

Product data sheet

201710002I

PCA9537_5

Modifications:

• Table 10: Corrected VPOR typ and max limit

• Added Section 3.1

PCA9537_5

20090507

Product data sheet

-

PCA9537_4

Modifications:

• The format of this data sheet has been redesigned to comply with the new identity guidelines of

NXP Semiconductors.

• Legal texts have been adapted to the new company name where appropriate.

• Pin names changed from "I/O0, I/O1, I/O2, I/O3" to "IO0, IO1, IO2, IO3", respectively

• Section 6.4, 1st sentence: changed symbol from "tW" to "tw(rst)"

• Figure 5: changed symbol from "tpv" to "tv(Q)"

• Figure 8:

– changed symbol from "tph" to "th(D)"

– changed symbol from "tps" to "tsu(D)"

– changed symbol from "tiv" to "tv(INT)"

– changed symbol from "tir" to "trst(INT)"

• Table 9:

– parameter description for symbol VI/O changed from "DC voltage on an I/O" to "voltage on an

input/output pin"

– parameter description for symbol ISS changed from "supply current" to "ground supply current"

– symbol/parameter changed from "II/O, DC output current on an I/O" to "IO(IOn), output current on

pin IOn"

• Table 10, sub-section "Supplies":

– symbol/parameter changed from "Istbl, Standby current" to "IstbL, LOW-level standby current"

– symbol/parameter changed from "Istbh, Standby current" to "IstbH, HIGH-level standby current"

• Table 11, sub-section "Port timing":

– symbol/parameter changed from "tPV, Output data valid" to "tv(Q), data output valid time"

– symbol/parameter changed from "tPS, Input data setup time" to "tsu(D), data input set-up time"

– symbol/parameter changed from "tPH, Input data hold time" to "th(D), data input hold time"

• Table 11, sub-section "Interrupt timing":

– symbol/parameter changed from "tIV, Interrupt valid" to "tv(INT), valid time on pin INT"

– symbol/parameter changed from "tIR, Interrupt reset" to "trst(INT), reset time on pin INT"

Table 16. Revision history

PCA9537

All information provided in this document is subject to legal disclaimers.

© NXP B.V. 2021. All rights reserved.

Product data sheet

Rev. 7 — 8 September 2021

COMPANY PUBLIC

20 / 25