Environmental Sensors Evaluation Kit Manual

R36UH0011EU0103 Rev.1.03

Jul 30, 2024

Page 4

1.

Setup

1.1

Initial Startup

To set up and operate the Evaluation Kit (EVK), refer to the Quick Start Guide included in the kit.

1.2

Required User Equipment

By default, the internal supply voltage for powering the sensor board is generated from the USB voltage supplied

by the user’s computer via the USB cable. If there is a need for currents higher than the defined USB Standard

(typically 500mA at 5V), an external voltage supply source can be used instead of the internally generated

voltage supply provided on the communication board.

The external supply powers only the sensor modules and not the communication board itself. The supply must

meet the following requirements:

■

Voltage 1.8V to 3.3V

■

Current supply capability must meet the requirements of the connected sensors

1.3

User Computer Requirements

1.3.1.

Computer Requirements

Windows®-based computer is required for interfacing with the EVK and configuring the gas sensor modules. The

user must download and install the Environmental Sensors Evaluation Software (ES-Eval).

The computer must meet the following requirements:

■

1GB RAM

■

Hard drive with at least 1GB free space

■

1 USB port

■

Windows 7, 8, 10, or 11

■

Internet access for initial download of the drivers and software

Important: Before installing and activating the software, assemble and connect the hardware for the kit to the

user’s computer according to steps 1 to 3 in section 1.5.

1.4

Software Installation and Setup

Complete the following procedure to download and install the Environmental Sensors Evaluation Software

(ES-Eval) with the kit connected:

1.

Download the Environmental Sensors Evaluation Software (ES-Eval) file. This file can also be downloaded

from any Renesas sensor product page.

2.

Double-click on the executable Installer file to start and follow the installation steps.