1

OUT

2

FB

3

GND

4

EN

5

DNC

6

IN

Not to scale

Thermal

Pad

3

TLV759P

www.ti.com

SBVS352A – APRIL 2018 – REVISED DECEMBER 2018

Submit Documentation Feedback

Copyright © 2018, Texas Instruments Incorporated

5 Pin Configuration and Functions

DRV Package

6-Pin Adjustable WSON

Top View

Pin Functions

PIN

I/O

DESCRIPTION

NAME

NO.

DNC

5

—

Do not connect

EN

4

Input

Enable pin. Drive EN greater than VEN(HI) to turn on the regulator.

Drive EN less than VEN(LO) to put the LDO into shutdown mode.

FB

2

—

This pin is used as an input to the control loop error amplifier and is used to set the

output voltage of the LDO.

GND

3

—

Ground pin

IN

6

Input

Input pin. For best transient response and to minimize input impedance, use the

recommended value or larger ceramic capacitor from IN to ground as listed in the

Recommended Operating Conditions table and the Input and Output Capacitor Selection

section. Place the input capacitor as close to the output of the device as possible.

OUT

1

Output

Regulated output voltage pin. A capacitor is required from OUT to ground for stability.

For best transient response, use the nominal recommended value or larger ceramic

capacitor from OUT to ground; see the Recommended Operating Conditions table and

the Input and Output Capacitor Selection section. Place the output capacitor as close to

output of the device as possible.

Thermal pad

Pad

—

Connect the thermal pad to a large area GND plane for improved thermal performance.

(1)

Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings

only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended

Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

The absolute maximum rating is VIN + 0.3 V or 6.0 V, whichever is smaller

6 Specifications

6.1 Absolute Maximum Ratings

over operating free-air temperature range (unless otherwise noted)

(1)

MIN

MAX

UNIT

Supply voltage, VIN

–0.3

6.5

V

Enable voltage, VEN

–0.3

6.5

V

Output voltage, VOUT

–0.3

VIN + 0.3

(2)

V

Operating junction temperature, TJ

–40

150

°C

Storage temperature, Tstg

–65

150

°C