L9678P datasheet(24/215 Pages) STMICROELECTRONICS

24 / 215 page

Start-up power control

L9678P, L9678P-S

24/216

DS11626 Rev 9

Figure 4. Wake-up input signal behaviour

Condition summary:

1. No change of sleep mode state but current consumption may exceed specification for

sleep mode.

2. The sleep mode current returns within the specified limits.

3. Power supply exits sleep mode. Switchers start operating if applicable voltages exceed

under voltage lockouts. As Twakeup time-out is not elapsed, a low level at WAKEUP

instantaneously sends the system back to sleep.

4. Sleep Reset is released and the entire system starts operating. A SPI command to

enter sleep state would be ignored.

5. No change in system status, a SPI command to enter sleep state would be ignored.

6. No change in system status, but a SPI command to turn off switchers would be

accepted and turn the system off.

With the below table, all the functionalities of the device are shown with respect to the power

states. When one function is flagged, the related circuitry cannot be activated on that state.

GAPGPS01113

WAKEUP

<1ms

1ms

<1ms

1ms

10ms

SLEEP MODE

ACTIVE MODE

PASSIVE MODE

WU_on

WU_off

WakeUpFilt

Table 4. Functions disabling by state

Function

Power

Off

Wake-up

monitor

Awake Start-up

Run

Power

mode

shutdown

Wakeup detector

Internal regulator

ERBOOST regulator

VSUP regulator (L9678P-S only)

ER CAP charge current source

ER switch

COVRACT Output

VDD5 regulator

VDD3V3 regulator

Deployment drivers

VSF safing FET regulator

Remote sensor interfaces

(L9678P-S only)

L9678P датащи(PDF) 24 Page - STMicroelectronics

L9678P датащи(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL