| поискавой системы для электроныых деталей |
|
ZL40262 датащи(PDF) 7 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
ZL40262 датащи(HTML) 7 Page - Microchip Technology |
|
7 / 36 page ![]() 2024 Microchip Technology Inc. and its subsidiaries. DS20006843A-page 7 ZL40262 1.1 Pin Descriptions All device inputs and outputs are HCSL unless described otherwise. The I/O column uses the following symbols: I – input, IPU – input with 300 kΩ internal pull-up resistor, IPD – input with 300 kΩ internal pull-down resistor, IAPU – input with 31 kΩ internal pull-up resistor, IAPD – input with 30 kΩ internal pull- down resistor, IAPU/APD – input biased to VDD/2 with 60 kΩ internal pull-up and pull-down resistors (30 kΩ equivalent), O – output, I/O – Input/Output pin, NC – No connect pin, P – power supply pin. TABLE 1-1: PIN DESCRIPTION Pin Number Pin Name Type Description Input Reference 20 IN0_p IAPD IAPU/APD Input Differential or Single Ended Reference Input frequency range 0 Hz to 400 MHz. Non-inverting inputs (_p) are pulled down with internal 30 kΩ pull-down resistors. Inverting inputs (_n) are pulled up and pulled down with 60 kΩ internal resistors (30 kΩ equivalent) to keep inverting input voltages at VDD/2 when inverting inputs are left floating (device fed with a single ended reference). 19 IN0_n Output Clocks 12 OUT0_p O Ultra-Low Additive Jitter Differential HCSL Outputs 0 to 1 Output frequency range 0 MHz to 400 MHz. 11 OUT0_n 9 OUT1_p 8 OUT1_n Control 13 OE0_b IPD Output Enable. Logic level on these pins enables/disables corresponding outputs. 10 OE1_b OEn_b OUTn_p/n 0 Active 1 High-Z (outputs p/n will be low/low because of 50 Ω shunt resistors—see recommended output termina- tion) Power and Ground 1 VDD P Positive Supply Voltage. Connect to 3.3V or 2.5V supply. 6 VDDO P Positive Supply Voltage for Differential Outputs. Connect 3.3V or 2.5V power supply. VDDO does not have to be connected to the same voltage level as VDD. 15 3 IC0 IC1 IPD Internal Connection. For normal operation connect to VDD or pull-up with 1 kΩ resistor. 18 4 NC NC No Connect. Leave open. 5 16 17 2 GND P Ground. Connect to the ground. 7 14 E-Pad |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |