BMP280 datasheet(30/49 Pages) BOSCH

30 / 49 page

Bosch Sensortec | BMP280 Data sheet

30 |

Modifications reserved | Data subject to change without notice

Document number: BST-BMP280-DS001-26 Revision_1.26_102021

The SPI interface uses the following pins:

•

CSB: chip select, active low

•

SCK: serial clock

•

SDI:

serial data input; data input/output in 3-wire mode

•

SDO: serial data output; hi-Z in 3-wire mode

Refer to chapter 6 for connection instructions.

CSB is active low and has an integrated pull-up resistor. Data on SDI is latched by the device at SCK

rising edge and SDO is changed at SCK falling edge. Communication starts when CSB goes to low

and stops when CSB goes to high; during these transitions on CSB, SCK must be stable. The SPI

protocol is shown in Figure 9. For timing details, please review Table 28

CSB

SCK

SDI

AD6 AD5 AD4 AD3 AD2 AD1 AD0

DI5

DI4

DI3

DI2

DI1

DI0

DI7

DI6

SDO

DO5 DO4 DO3 DO2 DO1 DO0

DO7 DO6

tri-state

Figure 9: SPI protocol (shown for mode ‘11’ in 4-wire configuration)

In SPI mode, only 7 bits of the register addresses are used; the MSB of register address is not used

and replaced by a read/write bit (RW = ‘0’ for write and RW = ‘1’ for read).

Example: address 0xF7 is accessed by using SPI register address 0x77. For write access, the byte

0x77 is transferred, for read access, the byte 0xF7 is transferred.

5.3.1

SPI write

Writing is done by lowering CSB and sending pairs control bytes and register data. The control bytes

consist of the SPI register address (= full register address without bit 7) and the write command (bit7 =

RW = ‘0’). Several pairs can be written without raising CSB. The transaction is ended by a raising

CSB. The SPI write protocol is depicted in Figure 10.

Start RW

Stop

bit7

bit6

bit5

bit4

bit3

bit2

bit1 bit0

bit7

bit6

bit5

bit4

bit3

bit2

bit1 bit0

Control byte

CSB

Data byte

Data register - adress F5h

CSB

Control byte

Data byte

Data register - address F4h

Figure 10: SPI multiple byte write (not auto-incremented)

5.3.2

SPI read

Reading is done by lowering CSB and first sending one control byte. The control bytes consist of the

SPI register address (= full register address without bit 7) and the read command (bit 7 = RW = ‘1’).

After writing the control byte, data is sent out of the SDO pin (SDI in 3-wire mode); the register address

is automatically incremented. The SPI read protocol is shown in Figure 11.

BMP280 датащи(PDF) 30 Page - Bosch Sensortec GmbH

BMP280 датащи(HTML) 30 Page - Bosch Sensortec GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

датащи скачать

ссылки URL