BME280 datasheet(21/60 Pages) BOSCH

21 / 60 page

Bosch Sensortec | BME280 Data sheet

21 | 60

Modifications reserved | Data subject to change without notice

Document number: BST-BME280-DS001-23 Revision_1.23_012022

Table 10: Settings and performance for gaming

Suggested settings for gaming

Sensor mode

normal mode, tstandby = 0.5 ms

Oversampling settings

pressure ×4, temperature ×1, humidity ×0

IIR filter settings

filter coefficient 16

Performance for suggested settings

Current consumption

581 µA

RMS Noise

0.3 Pa / 2.5 cm

Data output rate

83 Hz

Filter bandwidth

1.75 Hz

Response time (75%)

0.3 s

3.6 Noise

The noise depends on the oversampling and, for pressure and temperature, on the filter setting used.

The stated values were determined in a controlled environment and are based on the average

standard deviation of 32 consecutive measurement points taken at highest sampling speed. This is

needed in order to exclude long term drifts from the noise measurement. The noise depends both on

humidity/pressure oversampling and temperature oversampling, since the temperature value is used

for humidity/pressure temperature compensation. The oversampling combinations use below results in

an optimal power to noise ratio.

Table 11: Noise and current for humidity

Humidity / temperature

oversampling setting

Typical RMS noise in

humidity [%RH] at 25 °C

Typ. current [µA] at 1 Hz forced

mode, 25 °C, humidity and

temperature measurement, incl.

IDDSM

×1 / ×1

0.07

1.8

×2 / ×1

0.05

2.5

×4 / ×1

0.04

3.8

×8 / ×1

0.03

6.5

×16 / ×1

0.02

11.7

BME280 датащи(PDF) 21 Page - Bosch Sensortec GmbH

BME280 датащи(HTML) 21 Page - Bosch Sensortec GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

датащи скачать

ссылки URL