7.2.1.1 Design Requirements

For this application, the design requirements are as follows:

• VS+ = 5V, VS– = –5V, VCM = GND, REFA = GND

• IREF (1µA) connected to I2

• Input current range: 10nA ≤ I1 ≤ 100µA

• Photodiode: GP8195-12

– VR = 5V

– 20pA dark current (typical)

– 1pF typical capacitance (1.5pF maximum)

– Spectral response range from λ = 0.9μm to λ = 1.7μm

For bench testing of the system, the following configuration is used:

• Laser diode: LPS-1310-FC

– λ = 1.31μm

– Threshold current 5mA to 20mA

– Current control mode used

• Laser controller: THOR CLD1010

• Variable attenuator: VOA50-FC-SM 50dB in-line

• External modulation: Agilent 33500 30MHz waveform generator

7.2.1.2 Detailed Design Procedure

The G8195-12 photodiode was used with a fixed reverse bias voltage of 5V. The cathode was connected to

the VS+ 5V supply, and the anode to the I1 pin. GND is used for the VCM potential. The IBIAS feature and

REF165 voltage reference were not needed; therefore, the IBIAS and REF165 pins are left floating. The auxiliary

amplifier was not needed; therefore, the auxiliary amplifier was placed in a buffer configuration and used to

buffer the REF25 reference voltage.

GND was used for the REFA input of the logarithmic difference amplifier. The circuit output follows the

expression

VLOGOUT=250mV×log10 I11µA

(21)

such that the expected output for a 100nA input is –500mV, the expected output for a 10µA input is 250mV, and

so on.

www.ti.com

LOG200

SBOSA28A – AUGUST 2023 – REVISED DECEMBER 2024

Copyright © 2024 Texas Instruments Incorporated

Submit Document Feedback

25

Product Folder Links: LOG200