AD9956-VCOSLASHPCB datasheet(28/32 Pages) AD

28 / 32 page

AD9956

Rev. B | Page 28 of 32

CFR1 <17> Linear Sweep Enable

This bit turns on the frequency accumulator, which enables the

DDS to perform linear sweeping.

CFR1<17> = 0 (default). The DDS generates frequencies in

single-tone mode.

CFR1<17> = 1. The DDS uses the frequency accumulator to

sweep the frequency tuning word being sent to the phase

accumulator according to the values set in the delta frequency

tuning word and delta frequency ramp rate registers. For a

detailed explanation of this mode, see the linear sweep mode of

operation section.

CFR1 <16> Linear Sweep No Dwell

This bit dictates the behavior of the DDS core upon completion

of a linear sweep.

CFR1<16> = 0 (default). Upon reaching the upper value of the

sweep (FTW1), the DDS holds at the frequency value stored in

FTW1.

CFR1<16> = 1. Upon reaching the upper value of the sweep

(FTW1), the DDS returns to the initial value in the sweep

(FTW0) and continues to output that frequency until a new

sweep is initiated (by bringing PS0 low and then high).

CFR1 <15> LSB First Serial Data Mode

The serial data transfer to the device can be either MSB first or

LSB first. This bit controls that operation.

CFR1<15> = 0 (default). Serial data transfer to the device is in

MSB first mode.

CFR1<15> = 1. Serial data transfer to the device is in LSB first

mode.

CFR1<14> SDI/O Input Only (3-Wire Serial Data Mode)

The serial port on the AD9956 can act in 2-wire mode (SCLK

and SDI/O) or 3-wire mode (SCLK, SDI/O, and SDO). This bit

toggles the serial port between these two modes.

CFR1<14> = 0 (default). Serial data transfer to the device is in

2-wire mode. The SDI/O pin is bidirectional.

CFR1<14> = 1. Serial data transfer to the device is in 3-wire

mode. The SDI/O pin is input only.

CFR1<13:8> Open

Unused locations. Write a Logic 0.

CFR1<7> Digital Power-Down

This bit powers down the digital circuitry not directly related to

the I/O port. The I/O port functionality is not suspended, re-

gardless of the state of this bit.

CFR1<7> = 0 (default). Digital logic operating as normal.

CFR1<7> = 1. All digital logic not directly related to the I/O

port is powered down. Internal digital clocks are suspended.

CFR1<6> Phase Frequency Detector Input Power-Down

This bit controls the input buffers on the phase frequency de-

tector. It provides a way to gate external signals from the phase

frequency detector itself.

CFR1<6> = 0 (default). Phase frequency detector input buffers

are functioning normally.

CFR1<6> = 1. Phase frequency detector input buffers are pow-

ered down, isolating the phase frequency detector from the

outside world.

CFR1<5> PLLREF Crystal Enable

The AD9956 phase frequency detector has an on-chip oscillator

circuit. When enabled, the reference input to the phase fre-

quency detector (PLLREF/PLLREF) can be driven by a crystal.

CFR1<5> = 0 (default). Phase frequency detector reference

input operates as a standard analog input.

CFR1<5> = 1. Reference input oscillator circuit is enabled,

allowing the use of a crystal for the reference of the phase

frequency detector.

CFR1<4> SYNC_CLK Disable

If synchronization of multiple devices is not required, the spec-

tral energy resulting from this signal can be reduced by gating

the output buffer off. This function gates the internal clock

reference SYNC_CLK (SYSCLK/4) off of the SYNC_OUT pin.

CFR1<4> = 0 (default). SYNC_CLK signal is present on the

SYNC_OUT pin and is ready to be ported to other devices.

CFR1<4> = 1. SYNC_CLK signal is gated off, putting the

SYNC_OUT pin into a high impedance state.

CFR1<3> Automatic Synchronization

One of the synchronization modes of the AD9956 forces the

DDS core to derive the internal reference from an external ref-

erence supplied on the SYNC_IN pin. For details on synchroni-

zation modes for the DDS core, see the Synchronization Modes

for Multiple Devices section.

AD9956-VCO/PCB датащи(PDF) 28 Page - Analog Devices

AD9956-VCO/PCB датащи(HTML) 28 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

датащи скачать

ссылки URL