TCS3701 datasheet(44/67 Pages) OSRAM

44 / 67 page

Datasheet, Public

Page 43

[v2-00] 2022-Dec-15

Document Feedback

TCS3701 − Register Overview

Figure 51:

CFG11

Note(s):

1. Return to the Register Map (0xB4).

Addr: 0xB4

CFG11

Bit

Field

Reset

Type

Bit Description

7AINT_DIRECT

R/W

ALS Interrupt Direct. Enables the direct mode of

ALS interrupt. Interrupts (aint) are only generated

when adataX (selected by als_th_channel) moves

over the hysteresis edges (aint_ailt and aint_aiht). If

"0", interrupts are always generated if adataX is

above aiht or below ailt. The status of the ALS

interrupt is directly output on the INT or GPIO pin if

this mode is enabled and either of those pins are

configured to do so according to the INT_PINMAP

and GPIO_PINMAP settings.

6PINT_DIRECT

R/W

Proximity Interrupt Direct. If asserted, the

proximity interrupt has a hysteresis loop built into

the interrupt. After setting PEN = 1, the device

interrupts once PDATA is below PILT or above PIHT.

After this initial interrupt, the device will then

interrupt based on the direction that the PDATA

changes relative to each threshold. An interrupt is

generated when PDATA increases from below to

above PIHT to indicate a Detect condition, and an

interrupt is generated when PDATA decreases from

above to below PILT to indicate a Release condition.

With built-in hysteresis, it is no longer necessary to

change the thresholds between Detect or Release

interrupts. This bit applies to PINT0 and PINT1 by

using PDATA0 and PDATA1 respectively, as well as

the respective thresholds.

5:0

Reserved

TCS3701 датащи(PDF) 44 Page - OSRAM GmbH

TCS3701 датащи(HTML) 44 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

датащи скачать

ссылки URL