RG178SLASHU datasheet(26/39 Pages) ITT

26 / 39 page

Dimensions are shown in mm (inch)

Dimensions subject to change

130

RF Coaxial Connectors

Assembly Instructions

BAI-001

SMB/SMC Straight Connectors, Clamp Type for Braided Cable

1. Slide clamp nut, No. 1 washer, gasket and No. 2 washer over cable.

2. Trim cable to dimension shown taking care not to nick the braid.

3. Thumb braid out radially at right angles to dielectric.

4. A small chamfer may now be cut on the end of cable dielectric, to assist assembly of sleeve.

5. Slide sleeve over cable dielectric and under braid and outer jacket until the flange of the sleeve is

flush against the braid.

6. Move No.2 washer up to braid and trim braid flush with the flange of the sleeve.

7. Trim cable dielectric and center conductor to dimensions shown taking care not to nick the center

conductor.

8. Tin center conductor (DO NOT OVER TIN).

9. Slide rear insulator over cable.

10. Place a small solder preform made from 0,26 - 0,31 (.010 - .012) dia (28 swg) multi-core solder in

rear of contact.

11. Push contact on center conductor as far as possible. Heat center conductor and push until the

shoulder of the contact is flush against the rear insulator. Do not allow solder to protrude outside

spill hole.

12. Slide on front insulator flush against rear insulator (if not already assembled in body).

13. Move clamp nut, No. 1 washer and gasket up to No. 2 washer, slide on front body and tighten

clamp nut to required torque: 0,63 - 0,70 Nm (90 - 100 in. ozs.).

Only common cable retention features are shown in detail. Various body configurations can

apply.

CLAMP NUT

No. 1

WASHER

GASKET

No. 2

WASHER

SLEEVE

REAR

INSULATOR

CONTACT

FRONT

INSULATOR

FRONT

BODY

RG178/U датащи(PDF) 26 Page - ITT Industries

RG178/U датащи(HTML) 26 Page - ITT Industries

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

датащи скачать

ссылки URL