RG178SLASHU datasheet(19/39 Pages) ITT

19 / 39 page

Dimensions are shown in mm (inch)

Dimensions subject to change

123

Assy Insts

RF Coaxial Connectors

Assembly Instructions

AI-507 & AI-521

SMA Straight Connectors, Solderless Type for Semi-Rigid Cable

1. Trim cable to dimensions shown. Be careful not to nick center conductor. Ensure dielectric is flush.

Remove burrs from the copper jacket end. Pointing of the center conductor is essential.

2. Slide front body assembly onto cable. Firmly seat the clamp body collet on end of cable. Place

assembly into tool 050-000-0130000 with cable in holding jaws and cable end in piston die.

Squeeze tool handles fully and release.

Alternatively

3. Slide front body assembly onto cable, then slide cable into rear end of clamp body until it seats

firmly in counterbore.

NOTE: Where the separate contact versions are used the clamp body should be held securely in

any standard SMA jack to avoid undue pressure on the center contact. The center conductor

should click into place as it overcomes tension on the tynes.

4. Push front body assembly up over the clamp body then holding cable securely in counterbore, and

using any standard SMA jack as shown, complete assembly by simply tightening mating jack with

a torque of 0.79 to 1.13 Nm (7 to 10 in. lbs.).

Assembly Instruction No.

Part Number

AI 507

055-624-6703890

2,16

± 0,13 (.085 ± .005)

AI 521

055-607-6702890

1,78

± 0,13 (.085 ± .005)

AI 521

055-607-6203890

2,16

± 0,13 (.085 ± .005)

RG178/U датащи(PDF) 19 Page - ITT Industries