THGAMRG7T13BAIL

13

February 14th, 2019

© 2019 Toshiba Memory Corporation

ELECTRICAL CHARACTERISTICS

DC Characteristics

Absolute Maximum Ratings

The absolute maximum ratings of a semiconductor device are a set of specified parameter values, which must

not be exceeded during operation, even for an instant.

If any of these rating would be exceeded during operation, the device electrical characteristics may be irreparably

altered and the reliability and lifetime of the device can no longer be guaranteed. Moreover, these operations with

exceeded ratings may cause break down, damage, and/or degradation to any other equipment. Applications using

the device should be designed such that each maximum rating will never be exceeded in any operating conditions.

Before using, creating, and/or producing designs, refer to and comply with the precautions and conditions set forth

in this document.

Parameter

Symbol

Test Conditions

Min

Max

Unit

Supply voltage 1

VCC

-

-0.5

4.7

V

Supply voltage 2

VCCQ

-

-0.5

1.98

V

Voltage Input

VIO

-

-0.5

1.98

V

General

Parameter

Symbol

Test Conditions

Min

Max

Unit

Peak voltage on all lines

-

-

-0.5

VCCQ+0.5

V

All Inputs

Input Leakage Current (before initialization sequence Note 1

and/or the internal pull up resistors connected)

-

-

-100

100

μA

Input Leakage Current (after initialization sequence and the

internal pull up resistors disconnected)

-

-

-2

2

μA

All Outputs

Output Leakage Current (before initialization sequence)

-

-

-100

100

μA

Output Leakage Current (after initialization sequence)

-

-

-2

2

μA

Note 1: Initialization sequence is defined in Power-Up chapter of JEDEC/MMCA Standard

Power Supply Voltage

Parameter

Symbol

Test Conditions

Min

Max

Unit

Supply voltage 1

VCC

-

2.7

3.6

V

Supply voltage 2

VCCQ

-

1.7

1.95

V

2.7

3.6

V

Note 1: Once the power supply VCC or VCCQ falls below the minimum guaranteed voltage (for example, upon sudden power fail),

the voltage level of VCC or VCCQ shall be kept less than 0.5 V for at least 1ms before it goes beyond 0.5 V again.

Note 2: The host and device I/O power (VCCQ) shall be provided from same power supply.