AT83C24B datasheet(14/42 Pages) ATMEL

номер детали	AT83C24B

подробное описание детали	Smart Card Reader Interface with Power Management

PDF	42 Pages

Scroll/Zoom	100%

производитель	ATMEL [ATMEL Corporation]

домашняя страница	http://www.atmel.com

Logo

14 / 42 page

4234F–SCR–10/05

AT83C24

Activation Sequence

Hardware Activation (DC/DC started with CMDVCC)

Initial conditions:

CARDDET bit must be configured in accordance to the smart card connector polarity.

IT_SEL bit, CRST_SEL bit (see CONFIG4 register) must be set and CARDRST bit (see INTER-

FACE register) must be cleared. A smart card must be detected to enable to start the DC/DC

(CVCC= 3V or 5V).

The hardware activation sequence is started by hardware with CMDVCC pin going high to low. It

follows this automatic sequence:

•

CIO / CC4 / CC8 and IO / C4 / C8 are respectively linked together (IODIS bit is cleared).

•

The DC/DC is started and CVCC is set according to the A0/3V pin: 5V (Class A) if A0/3V is

High and 3V (Class B) is A0/3V is Low.

•

CCLK signal is enabled (CKSTOP bit cleared) when CVCC has settled to the programmed

voltage (see Electrical Characteristics) and the level on A1/RST is 0. The CCLK source can

be DCCLK signal, CLK signal , A2/CK signals or CARDCK bit (see Figures 5).

•

CRST signal is linked with A1/RST pin as soon as A1/RST pin level is 0. A rising edge on

A1/RST pin set the CRST pin.

Note:

1. The card must be deactivated to change the voltage.

Figure 10. Activation sequence with CMDVCC

Note:

For NDS applications, the host usually starts activation with A1/RST = 0.

CMDVCC

A1/RST

CCLK

CVCC

CRST

CIO

AT83C24B датащи(PDF) 14 Page - ATMEL Corporation