WM8766

Production Data

w

PD Rev 4.1 July 2005

14

In hardware mode (MODE pin set high) the MUTE pin becomes a bi-directional pin. Therefore if it is

driven low the device will never softmute. If it is driven high then all channels will softmute

immediately.

However if the pin is connected to a high impedance, or left floating, then when all three internal zero

flags are raised the WM8766 will also drive a weak logic high signal on the MUTE pin (output

impedance 10kOhms) which can be used to drive an external device.

It is not possible to perform analogue mute in Hardware mode.

Channel1

Softmute

Channel2

Softmute

Channel3

Softmute

MUTE

(pin)

CH1 ZFLAG

CH2 ZFLAG

CH3 ZFLAG

(Internal Signals)

10k

Ω

Figure 10 MUTE Logic in Hardware Mode

INPUT FORMAT SELECTION

In hardware mode, ML/I2S and MC/IWL become input controls for selection of input data format type

and input data word length for the DAC.

ML/I2S

MC/IWL

INPUT DATA MODE

0

0

24-bit right justified

0

1

20-bit right justified

1

0

16-bit I

1

1

24-bit I

Table 8 Input Format Selection

Note:

In 24 bit I

(LRCLK) are high for a minimum of 24 bit clocks (BCLK) and low for a minimum of 24 bit clocks. If

exactly 32 bit clocks occur in one left/right clock (16 high, 16 low) the chip will auto detect and run a

16 bit data mode.

DE-EMPHASIS CONTROL

In hardware mode, the MD/DM pin becomes an input control for selection of de-emphasis filtering to

be applied.

MD/DM

DE-EMPHASIS

0

Off

1

On

Table 9 De-emphasis Control