M58LR128HT85ZB5F datasheet(27/112 Pages) STMICROELECTRONICS

27 / 112 page

M58LR128HT, M58LR128HB

Command interface

27/112

4.12

Program/Erase Resume command

The Program/Erase Resume command is used to restart the program or erase operation

suspended by the Program/Erase Suspend command. One Bus Write cycle is required to

issue the command. The command can be issued to any address.

The Program/Erase Resume command does not change the read mode of the banks. If the

suspended bank was in Read Status Register, Read Electronic signature or Read CFI

Query mode the bank remains in that mode and outputs the corresponding data.

If a Program command is issued during a Block Erase Suspend, then the erase cannot be

resumed until the program operation has completed.

See Appendix C, Figure 22: Program Suspend & Resume flowchart and pseudocode, and

Figure 24: Erase Suspend & Resume flowchart and pseudocode, for flowcharts for using

the Program/Erase Resume command.

4.13

Protection Register Program command

The Protection Register Program command is used to program the user One-Time-

Programmable (OTP) segments of the Protection Register and the two Protection Register

Locks.

The device features 16 OTP segments of 128 bits and one OTP segment of 64 bits, as

shown in Figure 4: Protection Register memory map.

The segments are programmed one Word at a time. When shipped all bits in the segment

are set to ‘1’. The user can only program the bits to ‘0’.

Two Bus Write cycles are required to issue the Protection Register Program command.

●

The first bus cycle sets up the Protection Register Program command.

●

The second latches the address and data to be programmed to the Protection Register

and starts the Program/Erase Controller.

Read operations to the bank being programmed output the Status Register content after the

program operation has started.

Attempting to program a previously protected Protection Register will result in a Status

The Protection Register Program cannot be suspended. Dual operations between the

Parameter Bank and the Protection Register memory space are not allowed (see Table 15:

Dual operation limitations for details)

The two Protection Register Locks are used to protect the OTP segments from further

modification. The protection of the OTP segments is not reversible. Refer to Figure 4:

Protection Register memory map, and Table 8: Protection Register locks, for details on the

Lock bits.

See Appendix C, Figure 26: Protection Register Program flowchart and pseudocode, for a

flowchart for using the Protection Register Program command.

M58LR128HT85ZB5F датащи(PDF) 27 Page - STMicroelectronics

M58LR128HT85ZB5F датащи(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL