| поискавой системы для электроныых деталей |
|
MCP65R41 датащи(PDF) 22 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MCP65R41 датащи(HTML) 22 Page - Microchip Technology |
|
22 / 36 page ![]() MCP65R41/6 DS20002269C-page 22 2010-2020 Microchip Technology Inc. FIGURE 4-3: Protecting the Analog Inputs. It is also possible to connect the diodes to the left of the resistors R1 and R2. In this case, the currents through the diodes D1 and D2 need to be limited by some other mechanism. The resistor then serves as an in-rush cur- rent limiter; the DC current into the input pins (VIN+ and VIN-) should be very small. A significant amount of current can flow out of the inputs when the Common mode voltage (VCM) is below ground (VSS); see Figure 4-3. The applications that are high impedance may need to limit the usable voltage range. 4.1.3 PHASE REVERSAL The MCP65R41/6 comparator family uses CMOS tran- sistors at the input. They are designed to prevent phase inversion when the input pins exceed the supply voltages. Figure 2-3 shows an input voltage exceeding both supplies with no resulting phase inversion. 4.2 Push-Pull Output The push-pull output is designed to be compatible with CMOS and TTL logic, while the output transistors are configured to give a rail-to-rail output performance. They are driven with circuitry that minimizes any switching current (shoot-through current from supply to supply) when the output is transitioned from high-to- low, or from low-to-high (see Figures 2-17 and 2-18 for more information). 4.3 Externally Set Hysteresis A greater flexibility in selecting the hysteresis (or the input trip points) is achieved by using external resistors. Hysteresis reduces output chattering when one input is slowly moving past the other. It also helps in systems where it is preferable not to cycle between high and low states too frequently (e.g., air conditioner thermostatic controls). Output chatter also increases the dynamic supply current. V1 R1 VDD D1 R2 VSS – (minimum expected V2) 2mA VOUT V2 R2 R3 D2 + – R1 VSS – (minimum expected V1) 2mA VPU RPU* * Pull-up resistor required for the MCP65R46 only. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |