Data Sheet G15640EJ3V0DS

10

µµµµPC4250

RECOMMENDED SOLDERING CONDITIONS

When soldering this product, it is highly recommended to observe the conditions as shown below. If other soldering

processes are used, or if the soldering is performed under different conditions, please make sure to consult with our sales

offices.

For more details, refer to our document "SEMICONDUCTOR DEVICE MOUNTING TECHNOLOGY MANUAL"(C10535E).

Type of Surface Mount Device

µµµµPC4250G2: 8-pin plastic SOP (5.72 mm (225))

Process

Conditions

Symbol

Infrared Ray Reflow

Peak temperature: 235°C or below (Package surface temperature),

Reflow time: 30 seconds or less (at 210°C or higher),

Maximum number of reflow processes: 3 time.

IR35-00-3

Vapor Phase Soldering

Peak temperature: 215°C or below (Package surface temperature),

Reflow time: 40 seconds or less (at 200°C or higher),

Maximum number of reflow processes: 3 time.

VP15-00-3

Wave Soldering

Solder temperature: 260°C or below, Flow time: 10 seconds or less,

Maximum number of flow processes: 1 time,

Pre-heating temperature: 120°C or below (Package surface temperature).

WS60-00-1

Partial Heating Method

Pin temperature: 300°C or below,

Heat time: 3 seconds or less (Per each side of the device).

–

Caution Apply only one kind of soldering condition to a device, except for "partial heating method", or the

device will be damaged by heat stress.

Type of Through-hole Device

µµµµPC4250C: 8-pin plastic DIP (7.62 mm (300))

Process

Conditions

Wave Soldering

(only to leads)

Solder temperature: 260°C or below,

Flow time: 10 seconds or less.

Partial Heating Method

Pin temperature: 300°C or below,

Heat time: 3 seconds or less (per each lead).

Caution For through-hole device, the wave soldering process must be applied only to leads, and make sure that

the package body does not get jet soldered.

5