MPC8347E datasheet(39/108 Pages) FREESCALE

39 / 108 page

MPC8347EA PowerQUICC II Pro Integrated Host Processor Hardware Specifications, Rev. 3

Freescale Semiconductor

Local Bus

Local bus clock to output high impedance for LAD/LDP

tLBKHOZ

—3.8

Notes:

1. The symbols for timing specifications follow the pattern of t(First two letters of functional block)(signal)(state) (reference)(state) for inputs

and t(First two letters of functional block)(reference)(state)(signal)(state) for outputs. For example, tLBIXKH1 symbolizes local bus timing

(LB) for the input (I) to go invalid (X) with respect to the time the tLBK clock reference (K) goes high (H), in this case for clock

one(1). Also, tLBKHOX symbolizes local bus timing (LB) for the tLBK clock reference (K) to go high (H), with respect to the output

(O) going invalid (X) or output hold time.

2. All timings are in reference to the rising edge of LSYNC_IN.

3. All signals are measured from OVDD/2 of the rising edge of LSYNC_IN to 0.4 × OVDD of the signal in question for 3.3 V

signaling levels.

4. Input timings are measured at the pin.

5.tLBOTOT1 should be used when RCWH[LALE] is not set and when the load on the LALE output pin is at least 10 pF less than

the load on the LAD output pins.

6.tLBOTOT2 should be used when RCWH[LALE] is set and when the load on the LALE output pin is at least 10 pF less than the

load on the LAD output pins.

7.tLBOTOT3 should be used when RCWH[LALE] is set and when the load on the LALE output pin equals the load on the LAD

output pins.

8. For active/float timing measurements, the Hi-Z or off state is defined to be when the total current delivered through the

component pin is less than or equal to that of the leakage current specification.

Table 37. Local Bus General Timing Parameters—DLL on (continued)

Parameter

Symbol 1

Min

Max

Unit

Notes

MPC8347E датащи(PDF) 39 Page - Freescale Semiconductor, Inc