28

AT25DF011

DS-25DF011–032I–03/2022

The Reset command has no effect on the states of the Configuration Register or RSTE bit in the Status Register. The

WEL however, will be reset back to its default state.

The complete opcode and confirmation byte must be clocked into the device before the CS pin is deasserted, and the CS

pin must be deasserted on an even byte boundary (multiples of eight bits); otherwise, no Reset operation will be

performed.

Figure 12-9. Reset

13.

Electrical Specifications

SCK

CS

SI

SO

MSB

23

1

0

1111000

67

5

4

Opcode

Confirmation Byte In

10 11

9

814 15

13

12

0

MSB

1101000

0

High-impedance

Temperature under Bias. . . . . . . . -55

C to +125C

*Notice: Stresses beyond those listed under “Absolute

Maximum Ratings” may cause permanent damage to

the device. This is a stress rating only and functional

operation of the device at these or any other

conditions beyond those indicated in the operational

sections of this specification is not implied. Exposure

to absolute maximum rating conditions for extended

periods may affect device reliability. Voltage extremes

referenced in the “Absolute Maximum Ratings” are

intended to accommodate short duration

undershoot/overshoot conditions and does not imply

or guarantee functional device operation at these

levels for any extended period of time.

Storage Temperature . . . . . . . . . . -65

C to +150C

Absolute Maximum Vcc . . . . . . . . . . . . . . . . 3.96V

All Output Voltages with Respect to Ground



. . . . . . . . . -0.6V to 4.2V (Max VCC of 3.6V + 0.6V)

All Input Voltages with Respect to Ground



(excluding VCC pin, including NC pins)

. . . . . . . . . -0.6V to 4.2V (Max VCC of 3.6V + 0.6V)

13.1 DC and AC Operating Range

AT25DF011

Operating Temperature (Case) (1)

Ind.

-40

C to 85C

VCC Power Supply

1.65V to 3.6V