L6725

Device description

11/27

5.3

Bypassing the LDO to avoid the voltage drop with low Vcc

maximum LDO output current is about 100mA and so the output voltage drop is 100mV, to

avoid this the LDO can be bypassed.

5.4

Internal and external references

It is possible to set the internal/external reference and the switching frequency by setting the

proper voltage at the EAREF pin. The maximum value of the external reference depends on the

maximum external reference is 2.5V (typ.).

●

●

●

Providing an external reference from 0V to 450mV the output voltage will be regulated but

some restrictions must be considered:

●

The minimum OVP threshold is set at 300mV;

●

The under-voltage-protection doesn't work;

To set the resistor divider it must be considered that a 100K pull-down resistor is integrated into

the device (see Figure 4.). Finally it must be taken into account that the voltage at the EAREF

Figure 3.

Bypassing the LDO