| поискавой системы для электроныых деталей |
|
CC2430-RTR1-F64Z датащи(PDF) 223 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
CC2430-RTR1-F64Z датащи(HTML) 223 Page - Texas Instruments |
|
223 / 234 page ![]() CC2430 CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A Page 223 of 232 16 Voltage Regulators The CC2430 includes two low drop-out voltage regulators. These are used to provide a 1.8 V power supply to the CC2430 analog and digital power supplies. Note: The voltage regulators should not be used to provide power to external circuits because of limited power sourcing capability and also due to noise considerations. The analog voltage regulator input pin AVDD_RREG is to be connected to the unregulated 2.0 to 3.6 V power supply. The regulated 1.8 V voltage output to the analog parts, is available on the RREG_OUT pin. The digital regulator input pin AVDD_DREG is also to be connected to the unregulated 2.0 to 3.6 V power supply. The output of the digital regulator is connected internally within the CC2430 to the digital power supply. The voltage regulators require external components as described in section 11 on page 29. 16.1 Voltage Regulators Power-on The analog voltage regulator is disabled by setting the RF register bit RFPWR.RREG_RADIO_PD to 1. When the analog voltage regulator is powered-on by clearing the RFPWR.RREG_RADIO_PD bit, there will be a delay before the regulator is enabled. This delay is programmable through the RFPWR RF register. The interrupt flag RFIF.IRQ_RREG_PD is set when the delay has expired. The delayed power-on can also be observed by polling the RF register bit RFPWR.ADI_RADIO_PD. The digital voltage regulator is disabled when the CC2430 is placed in power modes PM2 or PM3 (see section 13.10). When the voltage regulators are disabled, register and RAM contents will be retained while the unregulated 2.0 to 3.6 power supply is present. 17 Evaluation Software Chipcon provides users of CC2430 with a software program, SmartRF ® Studio, which may be used for radio performance and functionality evaluation. SmartRF ® Studio runs on Microsoft Windows 95/98 and Microsoft Windows NT/XP/2000. SmartRF ® Studio can be downloaded from Chipcon’s web page: http://www.chipcon.com |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |