MDEV-GPS-F4 datasheet(8/25 Pages) LINX

8 / 25 page

–

Module Power-up Sequence

The module requires a specific sequence to power up and begin normal

operation. When power is first applied the module enters a “ready-to-start”

state while the Real Time Clock (RTC) starts up and settles. It awaits a

pulse on the ON_OFF line to enter Full Power Mode.

The RTC start time is variable, so the host needs to either monitor the

RFPWRUP line for a high pulse or wait for at least one second before

pulsing the ON_OFF line. An example flowchart is shown in Figure 8.

Module Power-down Sequence

The module requires a controlled power-down sequence. Uncontrolled

removal of power while the module is operating carries the risk of data

corruption. The consequences of this corruption range from longer TTFF

to complete system failure. The appropriate procedure to remove power is

shown in Figure 9.

Start

Power on the

module

Wait for ≥1 second

Pull ON_OFF high

for ≥100ms

The module is in

Full Power Mode

second timer

expired?

End

Data output

from the

module?

Yes

Start

Send System turn

off message to the

module (117)

Wait for ≥1 second

for the module to

enter Hibernate

Mode

Pull ON_OFF high

for ≥100ms when

the module is in

Full Power Mode

Remove power

from the module

End

Figure 8: F4 Series GPS Receiver Power Power-up Sequence

Figure 9: F4 Series GPS Receiver Power Power-down Sequence

MDEV-GPS-F4 датащи(PDF) 8 Page - Linx Technologies

MDEV-GPS-F4 датащи(HTML) 8 Page - Linx Technologies

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

датащи скачать

ссылки URL