SN74HCS20 datasheet(11/23 Pages) TI1

11 / 23 page

SN74HCS20

www.ti.com

SCLS791A – MARCH 2020 – REVISED JUNE 2020

Product Folder Links: SN74HCS20

Submit Documentation Feedback

Typical Application (continued)

Thermal increase can be calculated using the information provided in Thermal Characteristics of Standard Linear

and Logic (SLL) Packages and Devices.

CAUTION

The maximum junction temperature, TJ(max) listed in the Absolute Maximum Ratings,

is an additional limitation to prevent damage to the device. Do not violate any values

listed in the Absolute Maximum Ratings. These limits are provided to prevent damage

to the device.

9.2.1.2 Input Considerations

Input signals must cross Vt-(min) to be considered a logic LOW, and Vt+(max) to be considered a logic HIGH. Do

not exceed the maximum input voltage range found in the Absolute Maximum Ratings.

Unused inputs must be terminated to either VCC or ground. These can be directly terminated if the input is

completely unused, or they can be connected with a pull-up or pull-down resistor if the input is to be used

sometimes, but not always. A pull-up resistor is used for a default state of HIGH, and a pull-down resistor is used

for a default state of LOW. The resistor size is limited by drive current of the controller, leakage current into the

SN74HCS20, as specified in the Electrical Characteristics, and the desired input transition rate. A 10-kΩ resistor

value is often used due to these factors.

The SN74HCS20 has no input signal transition rate requirements because it has Schmitt-trigger inputs.

Another benefit to having Schmitt-trigger inputs is the ability to reject noise. Noise with a large enough amplitude

can still cause issues. To know how much noise is too much, please refer to the ΔVT(min) in the Electrical

Characteristics. This hysteresis value will provide the peak-to-peak limit.

Unlike what happens with standard CMOS inputs, Schmitt-trigger inputs can be held at any valid value without

causing huge increases in power consumption. The typical additional current caused by holding an input at a

value other than VCC or ground is plotted in the Typical Characteristics.

Refer to the Feature Description for additional information regarding the inputs for this device.

9.2.1.3 Output Considerations

The positive supply voltage is used to produce the output HIGH voltage. Drawing current from the output will

decrease the output voltage as specified by the VOH specification in the Electrical Characteristics. Similarly, the

ground voltage is used to produce the output LOW voltage. Sinking current into the output will increase the

output voltage as specified by the VOL specification in the Electrical Characteristics.

Unused outputs can be left floating.

Refer to Feature Description for additional information regarding the outputs for this device.

SN74HCS20 датащи(PDF) 11 Page - Texas Instruments