CS61584A datasheet(34/54 Pages) CIRRUS

34 / 54 page

CS61584A

DS261PP5

10.5

Run-Test/Idle State

This is a controller state between scan operations.

Once in this state, the controller remains in the state

as long as J-TMS is held low. The instruction reg-

ister and all test data registers retain their previous

state. When J-TMS is high and a rising edge is ap-

plied to J-TCK, the controller moves to the Select-

DR state.

10.6

Select-DR-Scan State

This is a temporary controller state and the instruc-

tion does not change in this state. The test data reg-

ister selected by the current instruction retains its

previous state. If J-TMS is held low and a rising

edge is applied to J-TCK when in this state, the

controller moves into the Capture-DR state and a

scan sequence for the selected test data register is

initiated. If J-TMS is held high and a rising edge

applied to J-TCK, the controller moves to the Se-

lect-IR-Scan state.

10.7

Capture-DR State

In this state, the Boundary Scan Register captures

input pin data if the current instruction is EXTEST

or SAMPLE/PRELOAD. The instruction does not

change in this state. The other test data registers,

which do not have parallel input, are not changed.

When the TAP controller is in this state and a rising

edge is applied to J-TCK, the controller enters the

Exit1-DR state if J-TMS is high or the Shift-DR

state if J-TMS is low.

10.8

Shift-DR State

In this controller state, the test data register con-

nected between J-TDI and J-TDO as a result of the

current instruction shifts data on stage toward its

serial output on each rising edge of J-TCK. The in-

struction does not change in this state. When the

TAP controller is in this state and a rising edge is

applied to J-TCK, the controller enters the Exit1-

DR state if J-TMS is high or remains in the Shift-

DR state if J-TMS is low.

10.9

Exit1-DR State

This is a temporary state. While in this state, if J-

TMS is held high, a rising edge applied to J-TCK

causes the controller to enter the Update-DR state,

which terminates the scanning process. If J-TMS is

held low and a rising edge is applied to J-TCK, the

controller enters the Pause-DR state. The test data

its previous value and the instruction does not

change during this state.

Test-Logic-Reset

Run-Test/Idle

Select-DR-Scan

Capture-DR

Shift-DR

Exit1-DR

Pause-DR

Exit2-DR

Update-DR

Select-IR-Scan

Capture-IR

Shift-IR

Exit1-IR

Pause-IR

Exit2-IR

Update-IR

Figure 24. TAP Controller State Diagram

CS61584A

DS261F1

CS61584A датащи(PDF) 34 Page - Cirrus Logic

CS61584A датащи(HTML) 34 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

датащи скачать

ссылки URL