M41T81SM6FT datasheet(16/29 Pages) STMICROELECTRONICS

16 / 29 page

M41T81S

16/29

Table 3. Alarm Repeat Modes

Watchdog Timer

The watchdog timer can be used to detect an out-

of-control microprocessor. The user programs the

watchdog timer by setting the desired amount of

time-out into the Watchdog Register, address 09h.

Bits BMB4-BMB0 store a binary multiplier and the

two lower order bits RB1-RB0 select the resolu-

tion, where 00 = 1/16 second, 01 = 1/4 second,

10 = 1 second, and 11 = 4 seconds. The amount

of time-out is then determined to be the multiplica-

tion of the five-bit multiplier value with the resolu-

tion. (For example: writing 00001110 in the

Watchdog Register = 3*1, or 3 seconds). If the

processor does not reset the timer within the spec-

ified period, the M41T81S sets the WDF (Watch-

dog Flag) and generates a watchdog interrupt.

The watchdog timer can be reset by having the mi-

croprocessor perform a WRITE of the Watchdog

Should the watchdog timer time-out, a value of

00h needs to be written to the Watchdog Register

in order to clear the IRQ/FT/OUT/SQW pin. This

will also disable the watchdog function until it is

again programmed correctly. A READ of the Flags

The watchdog function is automatically disabled

upon power-up and the Watchdog Register is

cleared. If the watchdog function is set, the fre-

quency test function is activated, and the SQWE

Bit is '0,' the watchdog function prevails and the

frequency test function is denied.

RPT5

RPT4

RPT3

RPT2

RPT1

Alarm Setting

Once per Second

Once per Minute

Once per Hour

000

Once per Day

Once per Month

000

Once per Year

M41T81SM6FT датащи(PDF) 16 Page - STMicroelectronics

M41T81SM6FT датащи(HTML) 16 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

датащи скачать

ссылки URL